BladeCluster Solution Manual

5. Check that the processes are started:
STATUS PROCESS $ZZKRN.#MSGMON
STATUS PROCESS $ZZKRN.#ZZSMN
STATUS PROCESS $ZZKRN.#ZZSCL
6. If either process is not started, refer to Starting and Stopping ServerNet Cluster Processes and
Subsystems (page 80).
Checking the ServerNet Cluster Subsystem
At an SCF prompt, type the following command to check if the ServerNet cluster subsystem is
started on the node:
STATUS SUBSYS $ZZSCL
If necessary, issue the SCF START SUBSYS $ZZSCL command to start the ServerNet cluster
subsystem in the node.
Checking the BladeCluster Configuration
The SCF STATUS CONN $ZZSCL command displays the status of the local node's connections
to the ServerNet cluster fabrics. This command is primarily for NonStop BladeSystems and NonStop
NS16000 series systems connected to BladeCluster Solution fabrics.
At an SCF prompt, type the following command to check the configuration of the BladeCluster:
SCF STATUS CONN $ZZSCL
An example display of this command follows:
\TEST.$SYSTEM.SYSTEM 30> scf status conn $ZZSCL
SCF - T9082H01 - (23JUN11) (02MAY11) - 06/16/2011 17:10:25 System \TEST
(C) 1986 Tandem (C) 2006 Hewlett Packard Development Company, L.P.
STATUS CONNECTION X Fabric Y Fabric
|----------------------------------------------------------------------------|
| System Topology | Blade Switch | Blade Switch |
| Hardware Prod Type | ServerNet Blade Switch | ServerNet Blade Switch |
| Cluster Topo Type | BladeCluster Short-Haul | BladeCluster Short-Haul |
| BladeCluster | Configured | Configured |
| BladeCluster/67x0 | Configured | Configured |
| Long Haul | Not configured | Not configured |
| Node Function | Anchor node | Anchor node |
| SvNet Node Number | 9 | 9 |
| Node Routing ID | 0x00077000 | 0x00077000 |
| Position in Zone | 1 | 1 |
| Zone Number | 2 | 2 |
| This Zone's Anchor | 9 | 9 |
| Max Num of Zones | 3 | 3 |
| Group Number | 100 | 100 |
| Module Number | 2 | 3 |
| Slot Number | 5 | 7 |
| Module Status | Up | Up |
|----------------------------------------------------------------------------|
| BladeCluster Solution License Files |
|----------------------------------------------------------------------------|
| Base License File: $SYSTEM.SYS00.ZLT988BC |
|----------------------------------------------------------------------------|
| Multi-Zone License File: Present in Anchor Node |
| Extra Long-Distance License File: $SYSTEM.SYS00.ZLT930LH |
|----------------------------------------------------------------------------|
The status fields for the STATUS CONN display are:
System Topology
is the system topology type for the modules that connect the node to the BladeCluster fabrics.
72 Checking Operations