BladeCluster Solution Manual

If $ZZKRN.#ZZSMN is configured but not started, use SCF to start it. This command starts a copy
of SANMAN on every available processor on the node. At an SCF prompt:
START PROCESS $ZZKRN.#ZZSMN
Starting MSGMON
If $ZZKRN.#MSGMON is configured but not started, use SCF to start it. This command starts a
copy of MSGMON on every available processor on the node. At an SCF prompt:
START PROCESS $ZZKRN.#MSGMON
Starting SNETMON
If $ZZKRN.#ZZSCL is configured but not started, use SCF to start it. At an SCF prompt:
START PROCESS $ZZKRN.#ZZSCL
Starting the Expand-Over-ServerNet Line-Handler Processes and Lines
If the line-handler processes are configured but not started, use SCF to start them.
NOTE: You can also use OSM to start the lines. For more information, see the OSM Add Node
to ServerNet Cluster online help.
1. At an SCF prompt, start the Expand-over-ServerNet line-handler processes as follows:
START DEVICE $ZZWAN.#linename
START DEVICE $ZZWAN.#SC004
2. Start the Expand-over-ServerNet lines as follows:
START LINE $SCxxx
START LINE $SC004
3. Check that the lines have started:
STATUS LINE $SC004
4. If the line-handler processes and lines do not start, refer to the Expand Network Management
and Troubleshooting Guide.
82 Starting and Stopping ServerNet Cluster Processes and Subsystems