CORBA 2.6.1A Readme (H-series and J-series)

Reader to read or print the IPSetup User Guide. Visit Adobe's
website to download the latest Adobe Acrobat Reader:
http://www.adobe.com
6. Use one of the following methods to move/copy files to the
Installation Subvolumes: (A) IPSetup only, or (B) IPSetup in
conjunction with DSM/SCM.
7. Follow the Pre-Installation Instructions in Section II below, if
any, before continuing to Step 8.
8. Run IPSetup to place and install (move NonStop Kernel files to the
correct ISVs) this product. If TCP/IP and FTP are unavailable, or
if you have problems with automatic file placement, use the
instructions in the IPSetup User Guide section "Manual Software
Placement Using the IPSetup TACL Program" to manually place
NonStop Kernel files.
This product contains both NonStop Kernel components and workstation
components. You may choose one, two, or three components to place
in one installation.
9. Follow the post-installation instructions in Section III below, if
any, after using IPSetup to place and install this product.
II. Pre-Installation Instructions
Prepare to run IPSetup by performing the following steps:
1. If you have an existing NonStop CORBA 2.6 installation,
stop all NonStop CORBA applications and subsystems.
Discussion: Eliminates file conflicts with the earlier
NonStop CORBA installations versions.
When updating the ISVs, IPSetup attempts to purge existing
files in the ISV during processing. If a NonStop CORBA
application is running, IPSetup is not able to purge files,
such as NSDHLPR, and terminates.
2. Ensure that you (the installation user) are not listed in
$SYSTEM.ZTCPIP.FTPUSERS.
Discussion: If you try to install products using IPSetup and
your user ID is listed in $SYSTEM.ZTCPIP.FTPUSERS, the
installation fails at the point where IPSetup tries to transfer
(ftp command) the files from the workstation to the NonStop
system. This failure occurs in a typical situation when
you install the product using the super.super ID and for common
security reasons, the super.super ID is forbidden ftp access.
III. Post-Installation Instructions
1. If you did not install the EMS template files using DSM/SCM,
invoke the INSTALL^TEMPLATES TACL macro to install the ZDOMTMPL