Data Transformation Engine Services Guide

Chapter 11 – AdapterSource and AdapterTarget Settings
90
OnFailure
The OnFailure setting supports rollback if the mapping does not complete successfully. The default
value is Rollback.
Value Description
Rollback
If the mapping does not complete successfully, target message or file
is not stored or process does not execute.
Commit
The adapter behaves as if the map was successful and takes the action
specified by the OnSuccess setting.
AdapterRetry
Use the AdapterRetry settings Switch, MaxAttempts, and Interval(Secs) to determine how to
respond to an interrupted adapter command process. If errors occur and retry is specified (Switch is set
to ON), the process is retried at the specified interval (using Interval(Secs)) up to as many times as
requested (using MaxAttempts).
AdapterRetry > Switch
Use the Switch setting to enable (ON) or disable (OFF) AdapterRetry for the adapter. The default
value is OFF.
Value Description
OFF
Disable AdapterRetry.
ON
Enable AdapterRetry.