dba/m Database Manager 7.1 Installation and Operations Manual

Verification of dba/m Database Manager Installation Macro
The installation procedure writes the output from installation macros to the terminal and a set of
output files stored in the GENOUT subvolume of the volume on which dba/m Database Manager
is installed. Check these outputs for errors and warnings. If there are any errors or warnings, call
Dba/m Database Manager Support before using dba/m.
Output File Contents Expected Errors
ODBGEN SQLCI output for creation of dba/m Database
Manager tables and index
Drop table error
OGCMDLOG SQLCOMP output for compilation of GCMDLOG None
OGDBSQL SQLCOMP output for compilation of GDBSQL None
OGDBAT SQLCOMP output for compilation of GDBAT None
OGDBDR SQLCOMP output for compilation of GDBDR None
OGDBROWS SQLCOMP output for compilation of GDBROWS None
OGDCOLL SQLCOMP output for compilation of GDCOLL None
OPWYCFG PATHMON cold start output None
OSMPLPRG SQLCOMP output for compilation of GSMPLPRG None
Install dba/m Database Manager on the Server (SUT Version)
This section describes the complete installation for SUT based versions. If you attempt to
install dba/m when you already have, all previous dba/m data may be deleted.
Log on as Super.<user> onto the NonStop System.
Setup Installation Environment
3. Set the volume to <dba/m Database Manager installation vol.ZDBAM>:
¾ VOLUME $<vol>.ZDBAM
4. Load the GENINSTL macro:
¾ LOAD/ KEEP 1/ GENINSTL
For details regarding Execution and Verification of Installation Macro, please refer to
Execute the dba/m Database Manager Installation Macro and Verification of dba/m
Database Manager Installation Macro Sections of Install dba/m Database Manager
(NPV Version).
dba/m Database Manager V7.1 Installation and Operations Manual – 540155-001 11