EPTRACE Manual

EPTRACE Manual—528811-002
3-1
3 EPTRACE Command Summary
This section describes EPTRACE command syntax in alphabetical order.
•
BUFFER on page 3-1
•
CD on page 3-1
•
CLEAR on page 3-2
•
ENV on page 3-2
•
EXIT on page 3-2
•
HELP on page 3-3
•
INFO on page 3-3
•
LOG on page 3-3
•
OBEY on page 3-4
•
SHOW on page 3-4
•
START on page 3-8
•
STOP on page 3-9
•
VOLUME on page 3-11
BUFFER
Use BUFFER to specify the maximum number of trace entries EPTRACE should report
about a program. The last BUFFER command invoked before the first START
command is used for the duration of the EPTRACE session. Set the buffer value
before using the START command.The buffer value is then enforced after the START
command is invoked.
nnn
is the number of tracing entries you should maintain. If you do not specify a
number of trace entries before invoking the first START command or do not specify
a number of trace entries, EPTRACE uses the default value of 200.
CD
The CD command specifies the current directory location EPTRACE can find the OSS
program for which it should report events.
BUFFER [nnn]
CD path