Expand Configuration and Management Manual (H06.03+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—529522-002
14-45
Expand-Over-NAM and Expand-Over-ServerNet
Line-Handler Processes
Framesize
specifies the maximum size frame that can be sent in the network; smaller frames
may be sent. The Expand subsystem also uses the FRAMESIZE modifier value to
calculate the packet size. The FRAMESIZE modifier value also determines the size
of the frame buffers.
Rsize
displays the time factor of the line for the Expand routing algorithm. RSIZE can be
0 if the time factor is set using some other modifier.
Speed
calculates the time factor of the line for the Expand routing algorithm.
LinePriority
can be set in the range 1 to 9. The default is 1. The higher the number, the lower
priority to use that line. If lines have equal priority, the relative line speeds and
transmission delays are used to select the next line.
StartUp
shows that the line will be disabled (OFF) or enabled (ON) after a system load.
Delay
reports the time interval between transmissions. See Time Values on page 14-6 for
a description of the time interval format.
Rxwindow
specifies the number of packets that the input-output process (IOP) will send to the
line-handler process before the line-handler process must send a reply.
Timerbind
specifies the time interval that the Expand-over-NAM or Expand-over-ServerNet
line-handler process will wait for a completion of its bind request to the NAM
process. See Time Values on page 14-6 for a description of the time interval
format
L2Timeout
specifies the time interval that the line-handler process will wait for a response to
request at Layer 2 before retrying. See Time Values on page 14-6 for a description
of the time interval format
Txwindow
reports the number of Expand packets that the line-handler process can send
before receiving a reply.