Expand Configuration and Management Manual (H06.03+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—529522-002
14-47
Considerations
requesting disconnection from the network service provided by the NAM process.
See Time Values on page 14-6 for a description of the time interval format.
Timerinactivity does not apply to Expand-over-ServerNet line-handler processes.
Connecttype
lists the Layer 2 Expand-over-NAM or Expand-over-ServerNet line-handler process
connect type. ACTIVEANDPASSIVE causes the network access method (NAM) to
first issue a call request and, if unsuccessful, wait for an incoming call request.
PASSIVE causes the NAM to wait for incoming call requests; it will not initiate
connect requests.
LineTF
is the line time factor. LINETF has a range of 0 to 186, with a default of 0 (unset). If
you set LINETF, it overrides the RSIZE, SPEED, or SPEEDK parameters in
calculating the time factor for the line (PATHTF overrides all parameters, including
LINETF). If LINETF is left unset (a zero value), this parameter is not used in setting
the time factor.
Considerations
You can display information about several lines with a single INFO command by
specifying multiple LINE objects using parentheses as follows:
LINE ( line-name , line-name [ , line-name ] ... )
INFO PROCESS Command
The INFO PROCESS command causes the display of selected information for the
network control process ($NCP). The information displayed can be the current attribute
settings for the local $NCP, the status of a selected path and the status of the started
lines that make up that path, or the status of the network as viewed from a selected
system.
The SUB and SEL options are not supported.
The INFO PROCESS command has the following syntax:
/OUT file-spec /
causes any SCF output generated by the command to be directed to the specified
file.
INFO [ /OUT file-spec / ] PROCESS $NCP
[ , { CONNECTS | LINESET | NETMAP | PATHSET | SUPERPATH |
SYSTEMS | RPT system-name } ]
[ , AT { system-list | * } ]
[ , TO { system-list | * } ]
[ , DETAIL ]