Expand Configuration and Management Manual (H06.03+)

Expand Modifiers
Expand Configuration and Management Manual—529522-002
16-3
Required Modifiers
DESTIPADDR Specifies the Internet Protocol (IP) address used by a remote
(destination) Expand-over-IP line-handler process.
Required by: Expand-over-IP line-handler processes if IPVER
is IPv4.
Default: 0.0.0.0.
DESTIPPORT Specifies the port number used by a remote (destination)
Expand-over-IP line-handler process.
Required by: Expand-over-IP line-handler processes if IPVER
is IPv4.
Default: 1024.
NEXTSYS Specifies the number of the system connected to the other end
of the line.
Required by: All types of Expand line-handler processes.
Default: 255.*
PVCNAME Specifies the name of a permanent virtual circuit (PVC).
Required by: Expand-over-ATM line-handler processes that
use PVC connections.
Default: None
SRCIPADDR Specifies the Internet Protocol (IP) address associated with a
NonStop TCP/IP process used by a local Expand-over-IP line-
handler process.
Required by: Expand-over-IP line-handler processes only.
Default: 0.0.0.0.
SRCIPPORT Specifies the port number used by a local Expand-over-IP line-
handler process.
Required by: Expand-over-IP line-handler processes only.
Default: 1024.
V6DESTIPADDR Specifies the destination NonStop TCP/IPv6 address used by
the remote Expand-over-IP line-handler process.
Required by: Expand-over-IP line-handler processes if IPVER
is IPv6.
Default: 0000:0000:0000:0000:0000:0000:0000:0000.
V6SRCIPADDR Specifies the source NonStop TCP/IPv6 address used by the
remote Expand-over-IP line-handler process.
Required by: Expand-over-IP line-handler processes if IPVER
is IPv6.
Default: 0000:0000:0000:0000:0000:0000:0000:0000.
*The default value for this modifier is invalid and must be changed.
Table 16-1. Required Modifiers (page 3 of 3)
Modifier Description