Expand Configuration and Management Manual (H06.03+)

Expand Modifiers
Expand Configuration and Management Manual—529522-002
16-26
TIMERRECONNECT n
commands. For the ADD DEVICE command, the format of the time is just plain
seconds.
Probes will continue to be sent out the number of times specified by the
RETRYPROBE attribute. If the TIMERPROBE/RETRYPROBE cycle expires without a
returned status, the Expand-over-NAM, Expand-over-ServerNet, Expand-over-ATM, or
Expand-over-IP line-handler process declares the network unavailable.
See also RETRYPROBE n and TIMERRECONNECT n.
TIMERRECONNECT n
Default: 30 for Expand-over-IP, Expand-over-ATM, and Expand-over-NAM
60 for Expand-over-ServerNet
Units: seconds
Range: 30 through 32767 for Expand-over-IP, Expand-over-ATM
0 through 32767 for Expand-over-NAM and Expand-over-ServerNet
This specifies the time interval that the Expand-over-NAM, Expand-over-ATM, Expand-
over-IP, or Expand-over-ServerNet line-handler process will wait for a connection
request to succeed. The range does not include 0. The time interval is specified in the
format described in Time Values on page 14-6; the time values section applies only to
ALTER PATH or ALTER LINE commands. For the ADD DEVICE command, the format
of the time is just plain seconds.
Expand line-handler processes on opposite ends of an X25AM line should use different
values for TIMERRECONNECT.
See also RETRYPROBE n and TIMERPROBE n.
TXWINDOW n
Default: 18 for satellite-connect lines
4 for all Expand-over-NAM lines
7 for all other line types
Units: Packets
Range: 2 through 7 for Expand-over-X.25, Expand-over-ServerNet, and
Expand-over-NAM lines
and 2 through 25 for Expand-over-IP and Expand-over-ATM lines
This modifier is applicable to all Expand line types.
For Expand-over-NAM and Expand-over-ServerNet line-handler processes, this
modifier specifies the number of packets that the Expand line-handler process can
send before receiving acknowledgment from the network access method (NAM)
process.
For satellite-connect and direct-connect line-handler processes, this modifier specifies
the number of packets that the Expand line-handler process can send before receiving
a reply. When using the multipacket frame feature with satellite-connect line-handler