Expand Configuration and Management Manual (H06.03+)

About This Manual

Expand Configuration and Management Manual—529522-002

Notation for Subnet

either vertically, with aligned braces on each side of the list, or horizontally, enclosed in

a pair of braces and separated by vertical lines. For example:

LBU { X | Y } POWER FAIL

process-name State changed from old-objstate to objstate

{ Operator Request. }

{ Unknown. }

| Vertical Line. A vertical line separates alternatives in a horizontal list that is enclosed in

brackets or braces. For example:

Transfer status: { OK | Failed }

% Percent Sign. A percent sign precedes a number that is not in decimal notation. The %þ

notation precedes an octal number. The %Bþ notation precedes a binary number. The

%H þnotation precedes a hexadecimal number. For example:

%005400

P=%p-register E=%e-register

Notation for Subnet

The following describes the notation conventions for SUBNET and subnet used in this

manual.

UPPERCASE LETTERS. Uppercase letters indicate the NonStop TCP/IP, Parallel Library

TCP/IP, or NonStop TCP/IPv6 subsystem SCF SUBNET object. For example:

Port A is identified by logical interface (LIF) 018, which uses a SUBNET on the

TCP/IP process named $ZB018 in processor 0.

lowercase letters. Lowercase letters indicate the general networking term for subnet. For

example:

Multicast datagrams that have a Time-To-Live (TTL) value of 1 are forwarded only

to hosts on the local subnet.

Change Bar Notation

Change bars are used to indicate substantive differences between this edition of the

manual and the preceding edition. Change bars are vertical rules placed in the right

margin of changed portions of text, figures, tables, examples, and so on. Change bars

highlight new or revised information. For example:

The message types specified in the REPORT clause are different in the COBOL85

environment and the Common Run-Time Environment (CRE).

The CRE has many new message types and some new message type codes for

old message types. In the CRE, the message type SYSTEM includes all messages

except LOGICAL-CLOSE and LOGICAL-OPEN.