Expand Configuration and Management Manual (H06.03+)

Configuration Quick Start
Expand Configuration and Management Manual—529522-002
1-13
Creating a Single-Line Expand Line-Handler
Process
Use the following command syntax for an Expand-over-ATM line-handler process
using an ATMSAP connection through the SLSA subsystem:
-> ADD DEVICE $ZZWAN.#device_name, PROFILE name,&
IOPOBJECT $SYSTEM.SYS00.LHOBJ, CPU cpunum, ALTCPU altcpu,&
TYPE (63,0), RSIZE 0, PATHTF 3, CALLTYPE_ATMSAP,&
LIFNAME lif-name, NEXTSYS sysnum
Note. If you want the Expand-over-ATM line-handler process to be part of a multi-CPU path,
specify the SUPERPATH_ON modifier in the SCF ADD DEVICE command. You can configure
a maximum of 16 paths in a multi-CPU path.
Table 1-5. SCF ADD DEVICE Syntax: Expand-Over-ATM
Parameter Description
device_name The name you want to assign to the Expand line-handler process.
name The name of the profile you created in Task 3: Add the Expand Line-
Handler Profile(s).
cpunum The number of the primary processor.
altcpu The number of the alternate processor.
atm_line The device name of the ATM line you want to associate with this
Expand-over-ATM line-handler process.
lif_name The name of the logical interface by which LAN access is known to
the system. This name can be up to eight characters long, null-
terminated, and case-sensitive. This modifier is only applicable to
Expand-over-ATM line-handler processes that use ATMSAP
connections though the SLSA subsystem.
pvc_name The name of the permanent virtual circuit (PVC) used by the Expand-
over-ATM line-handler process. This modifier is only applicable to
Expand-over-ATM line-handler processes that use PVC connections.
selector-byte A selector byte for the ATM line used by this Expand-over-ATM line-
handler process. The selector byte is the last (rightmost) byte of the
ATM address. This modifier is only applicable to Expand-over-ATM
line-handler processes that use SVC connections.
atm-address The 20-byte ATM address configured for the ATM line used by the
Expand-over-ATM line-handler process at the remote system. The
address must be preceded by the characters ISONSAP:%H and must
be enclosed in parentheses. This modifier is only applicable to
Expand-over-ATM line-handler processes that use SVC connections.
sysnum The number of the system connected to the other end of the line.
System numbers can be displayed using the SCF INFO PROCESS
$NCP, LINESET command.