Expand Configuration and Management Manual (H06.03+)

Configuration Quick Start
Expand Configuration and Management Manual—529522-002
1-15
Creating a Multi-Line Path
Creating a Multi-Line Path
This section describes how to configure a multi-line path.
1. Create the path-logical device.
-> ADD DEVICE $ZZWAN.#path_name, PROFILE name,&
IOPOBJECT $SYSTEM.SYS00.LHOBJ, CPU cpunum, ALTCPU altcpu,&
TYPE (63,1), RSIZE 0, PATHTF 3, NEXTSYS sysnum
process
•
For Expand-over-X.25: the name of an X25AM line-handler
process.
•
For Expand-over-SNA: the name of a SNAX/APN line-handler
process.
•
For Expand-over-ServerNet: must be $ZZSCL.
subdevice
•
For Expand-over-X.25: the name of an X25AM subdevice defined
for the X25AM process specified by process.
•
For Expand-over-SNA: the name of a local LU (with the NAM
protocol) defined for the SNAX/APN process specified by
process.
•
For Expand-over-ServerNet: this modifier is not used.
sysnum The number of the system connected to the other end of the line.
System numbers can be displayed using the SCF INFO PROCESS
$NCP, LINESET command.
Note. If you want the multi-line path to be part of a multi-CPU path, specify the
SUPERPATH_ON modifier in the SCF ADD DEVICE command. You can configure a
maximum of 16 paths in a multi-CPU path.
Table 1-7. ADD DEVICE Syntax: Path-Logical Device
Parameter Description
path_name The name you want to assign to the path-logical device.
name The name of the profile you created in Task 2, Step 2a.
cpunum The number of the primary processor.
altcpu The number of the alternate processor.
sysnum The number of the system connected to the other end of the multi-line
path. System numbers can be displayed using the SCF INFO
PROCESS $NCP, LINESET command.
Table 1-6. SCF ADD DEVICE Syntax: Expand-Over-X.25, Expand-Over-SNA, and
Expand-Over-ServerNet (page2of2)
Parameter Description