Fibre Channel ServerNet Adapter Installation and Support Guide (G06.28+, H06.03+)

Safety and Compliance
Fibre Channel ServerNet Adapter Installation and Support Guide—528254-012
Statements-6
Customer Installation and Servicing of Equipment
Customer Installation and Servicing of Equipment
The following statements pertain to safety issues regarding customer installation and
servicing of equipment described in this manual.
•
Keep door closed for normal operation.
•
The equipment must be installed near the receptacles for the power cords, and the
receptacles must be easily accessible to the user.
Applicability of Procedures, Instructions, and Examples
Consignes de sécurité à l'intention du client
Installation et entretien du système par le client
Les consignes de sécurité qui suivent concernent l'installation et l'entretien par le client
du système décrit dans le présent manuel.
•
Garder la porte fermée pendant le fonctionnement normal du système.
•
Installer le système à proximité des prises de courant nécessaires à son
branchement. Ces prises doivent être faciles d'accès.
Caution. If this unit has more than one power supply cord. Disconnect all power supply cords
to completely remove power from this unit.
WARNING. Do not touch the DC power connector on the S7400/7x000/8x000 PMF CRU after
you have unplugged the DC power cable from the CRU. It is possible to incur a severe energy
hazard for as long as fifteen (15) seconds after unplugging the cable. You can make sure the
CRU is safe to remove by testing (by using a volt meter) before touching the pins on the DC
power connector.
WARNING. The procedures and instructions and the examples of procedures and instructions
found in this manual apply only to the system enclosures and components found in
NonStop S-series servers which are described in the NonStop S-series server documentation.
Do not attempt to use these instructions with any other HP NonStop system equipment. You
can determine that your system is a NonStop S-series server by reading the label that appears
inside each system enclosure on the CRU in slot 50 or 55. The label includes the product
number, 195x, 196x, 197x or 198x series where x is any number. Read the label before
proceeding with any procedure or instruction found in this manual.
Attention. Cet appareil comporte plus d'un cordon d'alimentation. Débrancher tous les
cordons d’alimentation afin de couper complètement l'alimentation de cet équipment.