Fibre Channel ServerNet Adapter Installation and Support Guide (G06.28+, H06.03+)

Relocating an FCSA

Fibre Channel ServerNet Adapter Installation and Support Guide—528254-012

4-4

Resume Operations

Connect External Devices

Complete the procedure for Connect External Paths on page 2-19.

Alter or Add DISK Objects

If you are moving the FCSA but retaining the other path attributes, you can alter the

existing DISK path attributes as in this following example:

-> ALTER DISK $DISK02,

-> PRIMARYLOCATION (11,2,4), &

-> MBACKUPLOCATION (11,3,1)

If you are changing the path, you are changing the DISK path attributes, delete the

DISK objects by using the SCF DELETE command, and then add new DISK objects by

using the SCF ADD command. See Disk Configuration (ESS Connection) on

page 2-15 and Start the Disk on page 2-16.

Restart the Connected Devices

Use the SCF START command to restart each device connected to this adapter.

Troubleshooting

If the SCF STATUS SAC command shows that the FCSA SAC object is still in the

STARTING state after a few minutes, follow the procedure described in Verify That the

Connected Devices Are Operational on page 3-13.

If you receive file-system error -2 or error 66, or if the FCSA does not show up in OSM,

follow the procedures described in Troubleshoot the Disk Configuration on page 2-22.

Table 4-3. Update the DISK Objects Checklist

Step Description

Connect External Devices

Alter or Add DISK Objects

Restart the Connected Devices

Troubleshooting