H06.03 Software Installation and Upgrade Guide

Loading the Previous H06.03 and Resuming Normal
Operations
H06.03 Software Installation and Upgrade Guide—540066-002
10-3
Loading the System
4. Under Configuration, ensure that the correct paths are checked.
5. In the System Load dialog box, click Start System. The system load begins.
If you want to stop the load process, click Abort in the System Load dialog box.
You might wait up to 30 seconds before the abort takes effect.
If one or more of the startup event stream windows or startup TACL windows does
not launch on the system console after a few minutes (5 to 8 minutes), abort
system startup, close the OSM Low-Level Link, reboot the system console, and
restart the system load using the OSM Low-Level Link again.
6. Monitor the system startup process. Messages indicating the progress and
completion of the system load, as well as the reload of processors indicated in the
CIIN file, appear in these display locations on the system console.
When the system load is complete (the operating system is loaded successfully
into the memory of processor 0 or processor 1), the Detailed box on the System
Load dialog box displays:
SYSTEM STARTUP COMPLETE,
NSK RUNNING ON PROCESSOR n
•
If the system load fails, look for halt codes or messages displayed. For
recovery procedures, see the Processor Halt Codes Manual or Operator
Messages Manual.
•
After the operating system is running on the server, messages are no longer
sent to the Details box. See the event messages sent to the startup event
stream window.
Caution. Do not close the System Load dialog box while startup is in progress. If you attempt
to close the dialog box, an OSM message box indicates that the system startup process will be
stopped if you continue. If you stop a system startup before the operation finishes, the state of
your system cannot be predicted. You might need to perform another system startup to enable
the system to resume normal operation.