H06.03 Software Installation and Upgrade Guide

Installing SWID, DSM/SCM PVU, and Planner

Interface (PI) Client Software

H06.03 Software Installation and Upgrade Guide—540066-002

B-13

Install the DSM/SCM Client From ZDSMSCM

If you have to fall back, you can use the newly installed client software.

Alert (DSM/SCM T6031G01/H01 Client)

HP recommends that both the DSM/SCM product version and DSM/SCM client be at

the same version level at all times.

Determine Your DSM/SCM Client Software Version

To determine which version of DSM/SCM client software is installed, start the

DSM/SCM Planner Interface. Before prompting you to log on, the About DSM/SCM

window briefly displays version information. See Determine the Product Version of

DSM/SCM on the Host System on page B-1.

Determine the Current IP Address and Port Number

When you install DSM/SCM client software, you are prompted to enter the IP address

of the host system with which DSM/SCM communicates and the IP port number for the

DSM/SCM Winsock service.

If the DSM/SCM client software on your system console is configured to communicate

with a host system, determine the configured IP address and port number:

1. Start Windows Explorer. Open My Computer if not already open.

2. Double-click the hard drive icon to display its contents.

3. Open the DsmScm folder to display its contents.

4. In the Contents pane, double-click dsmscm.ini.

Note. Before you begin, back up your current DSM/SCM folder to save the configuration

information and the Planner Interface version.

Check that unnecessary PC programs are not running before you begin the DSM/SCM client

installation and that no DSM/SCM Build or Applies are in progress.