H06.03 Software Installation and Upgrade Guide

Installing SWID, DSM/SCM PVU, and Planner
Interface (PI) Client Software
H06.03 Software Installation and Upgrade Guide—540066-002
B-19
Install the DSM/SCM Client Software
8. Enter the IP port number for the Winsock service (see Determine the Current IP
Address and Port Number on page B-13), and click Next.
You are now prompted to enter the host system name.
9. Enter the host system name (or \noname if DSM/SCM is not currently configured to
communicate with a host system), and click Next to continue.
You are asked if you would like to run DSM/SCM.
10. Click No and go to Create an Emergency Repair Disk (ERD) or Automated
System Recovery (ASR) Disk on page B-20.
Note. If DSM/SCM is not currently configured to communicate with a host system, accept
the default IP port number. You can always change this value later by editing the
dsmscm.ini file.
VST040.vsd
VST045.vsd