H06.03 Software Installation and Upgrade Guide

Updating SWAN Concentrator CLIP Firmware
H06.03 Software Installation and Upgrade Guide—540066-002
C-6
Using SCF Commands to Aid in Updating SWAN
CLIP Firmware
c. Use the SCF STATUS SERVER command again to verify that the SWAN
adapter object is stopped.
5. From the Available Actions list, select Firmware Update to update the firmware for
that particular CLIP.
6. Click Perform action.
7. Monitor the progress in the Action Status menu. To view details of the action, click
Details.
8. To start the individual CLIP, select Start from the Available Actions list and click
Perform action.
9. Monitor the progress in the Action Status menu. To view details of the action, click
Details.
Using SCF Commands to Aid in Updating
SWAN CLIP Firmware
To List the Names of the SWAN Concentrators and CLIPs
Use the SCF NAMES ADAPTER command:
4> scf names adapter $zzwan.#*
SCF - T9082G02 - (16OCT98) (25SEP98) - 09/08/1999 15:53:26 System \ELI
Copyright Tandem Computers Incorporated 1986 - 1998
WANMgr Names ADAPTER $ZZWAN.#*
ADAPTER
$ZZWAN.#S00
$ZZWAN.#S01
To Check Location and Version of New SWAN CLIP Firmware
At a TACL prompt, enter the VPROC command:
TACL>VPROC $SYSTEM.CSSnn.C7953P00
where nn is the number specified during the Build/Apply phase of installing the
H06.03 RVU:
•
Use the SCF STATUS SERVER $ZZWAN.#conc-name.clip-num, DETAIL
command. For example:
$SYSTEM ZWANTOOL 14> scf status server $zzwan.#s01.3, detail
•
Or, use the WANLNCK utility (part of the SWAN Tools product placed in the
ZWANTOOL subvolume for H-series). A DEVICE must be configured and in the
STARTED state on the CLIP for this purpose. For example: