H06.03 Software Installation and Upgrade Guide

Updating SWAN Concentrator CLIP Firmware
H06.03 Software Installation and Upgrade Guide—540066-002
C-8
To Start the SWAN Concentrator and CLIPs
To Start the SWAN Concentrator and CLIPs
After the SWAN CLIP firmware has been updated, use the SCF START command to
start the updated SWAN concentrator and CLIPs.
SCF START ADAPTER $ZZWAN.#S01, SUB ALL
To Verify That the SWAN CLIPs Are Running the Latest Firmware
Verify that the updated SWAN CLIPs are in fact running at least the firmware version
by using one of the methods described under To Check Location and Version of New
SWAN CLIP Firmware on page C-6:
Enter the SCF STATUS SERVER $ZZWAN.#conc-name.clip-num, DETAIL
command:
$SYSTEM ZWANTOOL 14> scf status server $zzwan.#s01.3, detail
To Start Stopped Lines
Starting the SWAN concentrators in should bring all lines into the STARTED state.
Check the status of the lines and, if necessary, start any stopped lines on the started
CLIPs for each SWAN concentrator.