H06.03 Software Installation and Upgrade Guide

Overview of Installing the H06.03 RVU
H06.03 Software Installation and Upgrade Guide—540066-002
1-17
Managing ServerNet Adapter Firmware
°
RAM firmware: Operational firmware is downloaded to the FCSA when you
issue the first START DISK command to the first disk drive in the fibre-channel
loop.
°
Use the OSM Service Connection to check the FCSA’s firmware version and
update the firmware, if needed. If the Compare State shows Down-rev, update
the firmware.
•
G4SA. Operates with the existing NonStop S-series infrastructure. Use the OSM
Service Connection to check the G4SA’s firmware version (T0613G06) and update
the firmware, if needed. The following shows that the firmware is at the same
version:
For information on updating firmware, see the OSM online help on the OSM Multi-
Resource Action dialog box.
Table 1-4 shows the H-series ServerNet adapters that are supported on H-series for
H06.03. Note that both the FCSA and the G4SA are supported on G-series as well.
VST018.vsd
VST019.vsd