H06.03 Software Installation and Upgrade Guide

Contents

H06.03 Software Installation and Upgrade Guide—540066-002

B. Installing SWID, DSM/SCM PVU, and Planner

Interface (PI) Client Software (continued)

B. Installing SWID, DSM/SCM PVU, and Planner Interface (PI)

Client Software (continued)

Alert (DSM/SCM T6031G01/H01 Client) B-13

Determine Your DSM/SCM Client Software Version B-13

Determine the Current IP Address and Port Number B-13

Copy the ZDSMSCM Client File From the Host B-14

Install the DSM/SCM Client Software B-15

Create an Emergency Repair Disk (ERD) or Automated System Recovery (ASR)

Disk B-20

C. Updating SWAN Concentrator CLIP Firmware

Using the OSM Multi-Resource Actions Dialog Box to Update SWAN and SWAN 2

Firmware C-1

Step 1: Stop the SWAN Concentrator and CLIPs C-2

Step 2: Check the Location and Version of the SWAN Firmware C-3

Step 3: Initiate the Firmware Update C-3

Step 4: Start the SWAN Concentrator and CLIPs C-5

If a CLIP Fails to Update, Use the OSM Actions Dialog Box C-5

Using SCF Commands to Aid in Updating SWAN CLIP Firmware C-6

To List the Names of the SWAN Concentrators and CLIPs C-6

To Check Location and Version of New SWAN CLIP Firmware C-6

To Stop the CLIPs C-7

To Point SWAN Concentrators to the New Firmware Object Code File C-7

To Start the SWAN Concentrator and CLIPs C-8

To Verify That the SWAN CLIPs Are Running the Latest Firmware C-8

To Start Stopped Lines C-8

Glossary

Index