H06.03 Software Installation and Upgrade Guide

Loading the H06.03 RVU
H06.03 Software Installation and Upgrade Guide—540066-002
6-5
Completing the System Load (If Necessary)
Four OutsideView windows, consisting of two startup event stream windows (two
CNSL sessions) and two startup TACL windows (two CLCI sessions), are
automatically launched. It might take a few seconds before the windows appear.
If one or more of the startup event stream windows or startup TACL windows does
not launch on the system console after a few minutes (5 to 8 minutes), abort
system startup, close the OSM Low-Level Link, reboot the system console, and
restart the system load using the OSM Low-Level Link again.
6. Monitor the system startup process. Messages indicating the progress and
completion of the system load, as well as the reload of processors indicated in the
CIIN file, appear in these display locations on the system console.
When the system load is complete (the operating system is loaded successfully
into the memory of processor 0 or processor 1), the Detailed box on the System
Load dialog box displays:
SYSTEM STARTUP COMPLETE,
NSK RUNNING ON PROCESSOR n
7. If the system load fails, look for halt codes or messages displayed in the Detailed
box on System Startup dialog box. For recovery procedures, see the Processor
Halt Codes Manual or Operator Messages Manual.
Completing the System Load (If Necessary)
Loading the processors with the CIIN file is usually automatic. However, if the
operating system loaded successfully into processor 0 or processor 1, but the
commands in the CIIN file do not reload all remaining processors, use the RELOAD
TACL commands. You must be super ID (255,255) to load the processors.
1. From the system console, log on to the system as a super-group user (255,nnn)
and enter:
> RELOAD *, PRIME
2. To load an individual processor or processors, enter:
> RELOAD nn
where nn is the processor number of the processor you want to reload.
If the reload is initiated successfully, this message appears in a startup TACL
window on the system console screen:
PROCESSOR RELOAD: nn
For complete syntax, considerations, and examples of the TACL RELOAD
command, see the TACL Reference Manual.