iTP Secure WebServer System Administrators Guide (Version 7.5+)

Copying the iTP Secure WebServer Software from the Distribution Medium
If you are using IPSetup with a product CD, the following procedure is performed automatically,
so you can ignore these steps, and go to “Running the Setup Script” (page 40) after IPSetup
completes.
If you are not using IPSetup, follow these steps to copy the iTP Secure WebServer software from
the distribution medium:
1. Copy the product files to $ISV.ZWEB (where ISV is the name of your installation
NOTE: $ISV.ZWEB is an example cited in the text. The pax files can be placed anywhere
on the system.
2. On the NonStop system, log on as super ID, go to $ISV.ZWEB, and unpax the product files
using the TACL macro COPYOSS:
TACL> LOGON SUPER.SUPER
TACL> VOLUME $ISV.ZWEB
TACL> RUN COPYOSS T8996PAX
COPYOSS places the contents of the T8996PAX file into the version-specific OSS directory
located at:
/usr/tandem/webserver/<version>
where,
$<ISV> is the vproc of the RVU (for example: H03_15JUL10_ADX_H300_1).
The softdoc file, T8996ADX, is a text file that you can store in $<ISV>.SOFTDOC, or copy
to any other location on your HP NonStop server using the FUP DUP or FUP RENAME command.
3. To complete a typical installation of the iTP Secure WebServer, “Running the Setup Script”
(page 40) located in the OSS file system directory.
Running the Setup Script
HP recommends that a SUPER group user ID other than super ID be used when you run the setup
script.
1. If you must use EMS and it is not installed, install it now by using the procedure described in
“Event Management Service (EMS) Template Installation” (page 37).
2. To run the setup script, enter the OSS environment and execute the script.
For example:
TACL> LOGON SUPER.WEB
TACL> OSH
OSS: cd /usr/tandem/webserver/<version>
OSS: ./setup
Setup for iTP Secure WebServer on systems using TS/MP 2.2 or lower versions
After you perform the two steps, the setup script instructs you step-by-step through the installation
of the administration server and the iTP Secure WebServer. By default, the script installs the product
into the /usr/tandem/webserver directory. If you are logged on with a SUPER group user ID,
you can accept the default settings, unless you want to “Installing the Resource Locator” (page 44).
If you accept the default settings, you start running both the iTP Secure WebServer administration
interfaces and the iTP Secure WebServer. The script automatically backs up any existing
configuration files.
If you want to install the iTP Secure WebServer into an OSS directory other than
/usr/tandem/webserver, specify the desired installation directory as a parameter to the setup
script. For example:
40 Installing the iTP Secure WebServer