L700 (CTL700) Installation and User's Guide (G06.28+, H06.04+, J06.03+)
Table Of Contents
- Title Page
- Contents
- What's New
- About This Manual
- 1 Overview of the Tape Library
- 2 Unpacking the Tape Library
- 3 Installing the Tape Library
- 4 Controls and Indicators on the CTL700 Tape Library
- 5 Configuring and Testing the Tape Library
- Overview of Configuration
- Tape Library Capacity
- Entering Configuration Data
- Performing the Final Steps
- Initialization Sequence
- Testing the Tape Library
- 6 Operating the Tape Library
- Operating in Automated Mode
- Powering Off the Tape Library
- Operating In Manual Mode
- 7 Tape Drives in the CTL700 Tape Library
- 8 Configuring the CTL700 Tape Library for the NonStop SSeries Server
- 9 Managing Tape Drives
- A Configuring the CTL700 Tape Library for the NonStop NS-Series Server
- B Configuring the CTL700 Tape Library for the NonStop SSeries Server With the IOAM Enclosure
- C Configuring the CTL700 Tape Library for the NonStop BladeSystem Server
- Safety and Compliance
- Index
L700 (CTL700) Installation and User’s Guide—527338-008
1-1
1 Overview of the Tape Library
This section covers:
CTL700 Tape Library Product Overview
The CTL700 tape library is a fully automated tape cartridge storage and retrieval
subsystem. Depending on model and features selected, it can store from 168 to 630
data cartridges. The total numbers do not include the cartridges in the cartridge access
port (CAP) or the reserved cells.
The exchange rate for moving tape cartridges from cell to cell is 450 exchanges per
hour.
CTL700 Tape Library Product Overview 1-1
Compatibility 1-3
Software 1-4
Figure 1-1. The CTL700 Tape Library