L700 (CTL700) Installation and User's Guide (G06.28+, H06.04+, J06.03+)
Table Of Contents
- Title Page
- Contents
- What's New
- About This Manual
- 1 Overview of the Tape Library
- 2 Unpacking the Tape Library
- 3 Installing the Tape Library
- 4 Controls and Indicators on the CTL700 Tape Library
- 5 Configuring and Testing the Tape Library
- Overview of Configuration
- Tape Library Capacity
- Entering Configuration Data
- Performing the Final Steps
- Initialization Sequence
- Testing the Tape Library
- 6 Operating the Tape Library
- Operating in Automated Mode
- Powering Off the Tape Library
- Operating In Manual Mode
- 7 Tape Drives in the CTL700 Tape Library
- 8 Configuring the CTL700 Tape Library for the NonStop SSeries Server
- 9 Managing Tape Drives
- A Configuring the CTL700 Tape Library for the NonStop NS-Series Server
- B Configuring the CTL700 Tape Library for the NonStop SSeries Server With the IOAM Enclosure
- C Configuring the CTL700 Tape Library for the NonStop BladeSystem Server
- Safety and Compliance
- Index
Configuring the CTL700 Tape Library for the
NonStop BladeSystem Server
L700 (CTL700) Installation and User’s Guide—527338-008
C-3
Troubleshoot the Tape Configuration
Troubleshoot the Tape Configuration
•
Check that the processes on the CLIM are running and if they are not, start them.
•
If either of these conditions occur:
°
The SCF STATUS CLIM $ZZCIP.* command shows that the CLIM object is still
in the STARTING state after a few minutes, or
°
The SCF STATUS TAPE command shows that the tape drive is still in the
STARTING state after a few minutes
°
The OSM Service Connection indicates that the resource needs attention
Check for event messages in the Event Message Service (EMS) log. Use the OSM
Event Viewer to view the EMS log.
Refer to the Operator Messages Manual for cause, effect, and recovery
information for event messages.