L700 (CTL700) Installation and User's Guide (G06.28+, H06.04+, J06.03+)
Table Of Contents
- Title Page
- Contents
- What's New
- About This Manual
- 1 Overview of the Tape Library
- 2 Unpacking the Tape Library
- 3 Installing the Tape Library
- 4 Controls and Indicators on the CTL700 Tape Library
- 5 Configuring and Testing the Tape Library
- Overview of Configuration
- Tape Library Capacity
- Entering Configuration Data
- Performing the Final Steps
- Initialization Sequence
- Testing the Tape Library
- 6 Operating the Tape Library
- Operating in Automated Mode
- Powering Off the Tape Library
- Operating In Manual Mode
- 7 Tape Drives in the CTL700 Tape Library
- 8 Configuring the CTL700 Tape Library for the NonStop SSeries Server
- 9 Managing Tape Drives
- A Configuring the CTL700 Tape Library for the NonStop NS-Series Server
- B Configuring the CTL700 Tape Library for the NonStop SSeries Server With the IOAM Enclosure
- C Configuring the CTL700 Tape Library for the NonStop BladeSystem Server
- Safety and Compliance
- Index
L700 (CTL700) Installation and User’s Guide—527338-008
Statements-1
Safety and Compliance
This sections contains three types of required safety and compliance statements:
•
Regulatory compliance
•
Waste Electrical and Electronic Equipment (WEEE)
•
Safety
Regulatory Compliance Statements
The following regulatory compliance statements apply to the products documented by
this manual.
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio-frequency energy and, if not installed and used in accordance with the
instruction manual, may cause interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Any changes or modifications not expressly approved by Hewlett-Packard Computer
Corporation could void the user’s authority to operate this equipment.
Canadian Compliance
This class A digital apparatus meets all the requirements of the Canadian Interference-
Causing Equipment Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règelment sur
le matériel brouilleur du Canada.