L700 (CTL700) Installation and User's Guide (G06.28+, H06.04+, J06.03+)
Table Of Contents
- Title Page
- Contents
- What's New
- About This Manual
- 1 Overview of the Tape Library
- 2 Unpacking the Tape Library
- 3 Installing the Tape Library
- 4 Controls and Indicators on the CTL700 Tape Library
- 5 Configuring and Testing the Tape Library
- Overview of Configuration
- Tape Library Capacity
- Entering Configuration Data
- Performing the Final Steps
- Initialization Sequence
- Testing the Tape Library
- 6 Operating the Tape Library
- Operating in Automated Mode
- Powering Off the Tape Library
- Operating In Manual Mode
- 7 Tape Drives in the CTL700 Tape Library
- 8 Configuring the CTL700 Tape Library for the NonStop SSeries Server
- 9 Managing Tape Drives
- A Configuring the CTL700 Tape Library for the NonStop NS-Series Server
- B Configuring the CTL700 Tape Library for the NonStop SSeries Server With the IOAM Enclosure
- C Configuring the CTL700 Tape Library for the NonStop BladeSystem Server
- Safety and Compliance
- Index
Index
L700 (CTL700) Installation and User’s Guide—527338-008
Index-2
T
bringing up a tape drive 9-3
SCSI status 9-2
start command 9-3
start SCSI command 9-4
status of tape devices 9-1
stop command 9-5
stop SCSI command 9-6
using with a tape drive or library 9-1
SCSI bus terminating 3-12
SCSI cable paths 3-7
SCSI control connection 3-7
SCSI control path 3-7
SCSI data path 3-7
SCSI drive connections 3-9
Server connection 3-8
SPARC 5 3-7
Sun microsystems server 3-8
T
Tape cartridge 1-1
Tape drives 1-2
CT9841FC-1 1-2
M8503 1-2
M8608A 1-2
N1530A 1-2
Tape library
installing 3-1
operating 6-1
operator panel 4-1
overview 1-1
power switch 4-13
tape drives 7-1
testing 5-1
unpacking 2-7
Terminate SCSI bus 3-12
Theta motors 2-8
Theta shipping pin 2-8
Theta stop 3-1
Tools required 2-1
U
Unpacking preparation 2-3
Unpacking the CTL700 2-4
interior 2-7
positioning 2-6
removing from pallet 2-6
removing the shipping kit 2-6
securing the position 2-7
Z
Z carriage 2-8
Z carriage assembly 2-9
Z column 2-8, 3-2