L700 (CTL700) Installation and User's Guide (G06.28+, H06.04+, J06.03+)
Table Of Contents
- Title Page
- Contents
- What's New
- About This Manual
- 1 Overview of the Tape Library
- 2 Unpacking the Tape Library
- 3 Installing the Tape Library
- 4 Controls and Indicators on the CTL700 Tape Library
- 5 Configuring and Testing the Tape Library
- Overview of Configuration
- Tape Library Capacity
- Entering Configuration Data
- Performing the Final Steps
- Initialization Sequence
- Testing the Tape Library
- 6 Operating the Tape Library
- Operating in Automated Mode
- Powering Off the Tape Library
- Operating In Manual Mode
- 7 Tape Drives in the CTL700 Tape Library
- 8 Configuring the CTL700 Tape Library for the NonStop SSeries Server
- 9 Managing Tape Drives
- A Configuring the CTL700 Tape Library for the NonStop NS-Series Server
- B Configuring the CTL700 Tape Library for the NonStop SSeries Server With the IOAM Enclosure
- C Configuring the CTL700 Tape Library for the NonStop BladeSystem Server
- Safety and Compliance
- Index
Configuring and Testing the Tape Library
L700 (CTL700) Installation and User’s Guide—527338-008
5-4
Providing Configuration Information
Table 5-2. Tape Drive Configuration Form
Tape Library Configuration
The TAPE LIBRARY CONFIGURATION screen allows you to set:
•
Tape library SCSI ID (IPL of tape library required)
•
Drive fast load on or off
•
Date
•
Time
•
Operator panel screen characteristics
•
Drive SCSI IDs
Fast load enabled or disabled Automatically configured as enabled if cleaning
cartridges are installed in the reserved cells.
Cleaning cartridge life
Tape Drive # SCSI ID
ON or Off
Bus
Tape Drive
# SCSI ID
On or Off
Bus
Table 5-1. Tape Library Configuration Selection
Option Selection