L700 (CTL700) Installation and User's Guide (G06.28+, H06.04+, J06.03+)
Table Of Contents
- Title Page
- Contents
- What's New
- About This Manual
- 1 Overview of the Tape Library
- 2 Unpacking the Tape Library
- 3 Installing the Tape Library
- 4 Controls and Indicators on the CTL700 Tape Library
- 5 Configuring and Testing the Tape Library
- Overview of Configuration
- Tape Library Capacity
- Entering Configuration Data
- Performing the Final Steps
- Initialization Sequence
- Testing the Tape Library
- 6 Operating the Tape Library
- Operating in Automated Mode
- Powering Off the Tape Library
- Operating In Manual Mode
- 7 Tape Drives in the CTL700 Tape Library
- 8 Configuring the CTL700 Tape Library for the NonStop SSeries Server
- 9 Managing Tape Drives
- A Configuring the CTL700 Tape Library for the NonStop NS-Series Server
- B Configuring the CTL700 Tape Library for the NonStop SSeries Server With the IOAM Enclosure
- C Configuring the CTL700 Tape Library for the NonStop BladeSystem Server
- Safety and Compliance
- Index
Configuring and Testing the Tape Library
L700 (CTL700) Installation and User’s Guide—527338-008
5-7
Setting Screen Characteristics
3. At the editing screen:
a. Use the up and down arrow buttons to select a value for each portion (field) of
the date.
b. Use the SELECT button to move right to the next field.
c. Use the MENU button to move left to the previous field.
4. When the screen displays the desired setting, press the SELECT button from the
right-most field to save entries. Press the MENU button to abort.
5. To set other values, continue with the next subsection.
Setting the Time
1. From the LIBRARY CONFIG screen, line up the cursor with TIME.
2. Press the SELECT button. An editing screen appears.
3. At the editing screen:
a. Use the up and down arrow buttons to select a value for each portion (field) of
the time.
b. Use the SELECT button to move right to the next field.
c. Use the MENU button to move left to the previous field.
4. When the screen displays the desired setting, press the SELECT button from the
right-most field to save entries. Press the MENU button to abort.
5. To set other values, continue with the next subsection.
Setting Screen Characteristics
To change the contrast and backlight (brightness) of the operator screens:
1. From the LIBRARY CONFIG screen, line up the cursor with DISPLAY INFO.
2. Press the SELECT button. The display screen appears.
3. Use an arrow button to select the desired screen characteristic: CONTRAST or
BACKLIGHT. An edit screen appears.
4. On the editing screen, use the up and down arrow buttons to save the changes.
Press the MENU button to abort.
5. When the count value is correct, press the SELECT button to save the changes.
Press the MENU button to abort.
6. To set other values, continue with the next subsection.