L700 (CTL700) Installation and User's Guide (G06.28+, H06.04+, J06.03+)
Table Of Contents
- Title Page
- Contents
- What's New
- About This Manual
- 1 Overview of the Tape Library
- 2 Unpacking the Tape Library
- 3 Installing the Tape Library
- 4 Controls and Indicators on the CTL700 Tape Library
- 5 Configuring and Testing the Tape Library
- Overview of Configuration
- Tape Library Capacity
- Entering Configuration Data
- Performing the Final Steps
- Initialization Sequence
- Testing the Tape Library
- 6 Operating the Tape Library
- Operating in Automated Mode
- Powering Off the Tape Library
- Operating In Manual Mode
- 7 Tape Drives in the CTL700 Tape Library
- 8 Configuring the CTL700 Tape Library for the NonStop SSeries Server
- 9 Managing Tape Drives
- A Configuring the CTL700 Tape Library for the NonStop NS-Series Server
- B Configuring the CTL700 Tape Library for the NonStop SSeries Server With the IOAM Enclosure
- C Configuring the CTL700 Tape Library for the NonStop BladeSystem Server
- Safety and Compliance
- Index
Configuring and Testing the Tape Library
L700 (CTL700) Installation and User’s Guide—527338-008
5-17
Running Diagnostic Tests
8. Press SELECT. The GET/PUT option screen appears.
9. Follow the screen directions to set the number of times for the test to run.
10. At the “ARE YOU SURE?” prompt, confirm that the tape library is in maintenance
mode (offline) before beginning the test. Confirm by pressing the SELECT button.
11. After this diagnostic test runs to completion, press MENU to return to the
DIAGNOSTIC menu.
Running the Mount-Dismount Loop Diagnostic Test
The Mount-Dismount loop diagnostic test validates the ability of the robot to load and
unload a cartridge to a tape drive. The robot:
•
Retrieves a diagnostic tape cartridge
•
Loads the tape cartridge into a tape drive
When the drive dismounts the cartridge, the robot:
•
Retrieves the tape cartridge
•
Places it back in its reserved cell
To run the Mount-Dismount diagnostic test:
1. Check that both the tape library and target drive are offline.
2. Check that the main access door is closed and the tape library menu is displayed.
3. Check that there is a diagnostic cartridge in the reserved area.
4. From the Status screen, press the MENU button. The Main menu appears.
5. Use the down arrow button to select DIAGNOSTICS.
6. Press the SELECT button. The DIAGANOSTICS screen appears.
7. Use the down arrow button to select DRIVE DIAGNOSTICS.
8. Press SELECT. The list of available tape drives appears.
9. Use the arrow button to select the tape drive to be mounted.
10. Press the SELECT button. The list of drive diagnostic tests appears.
11. Use the arrow button to select MOUNT/DISMOUNT LOOP.
12. Press SELECT.
13. At the “ARE YOU SURE?” prompt, confirm that the tape library is in Maintenance
Mode (offline) before beginning the test. Confirm by pressing the SELECT button.
14. After this diagnostic test runs to completion, press the MENU button to return to
the DIAGNOSTICS menu.