L700 (CTL700) Installation and User's Guide (G06.28+, H06.04+, J06.03+)
Table Of Contents
- Title Page
- Contents
- What's New
- About This Manual
- 1 Overview of the Tape Library
- 2 Unpacking the Tape Library
- 3 Installing the Tape Library
- 4 Controls and Indicators on the CTL700 Tape Library
- 5 Configuring and Testing the Tape Library
- Overview of Configuration
- Tape Library Capacity
- Entering Configuration Data
- Performing the Final Steps
- Initialization Sequence
- Testing the Tape Library
- 6 Operating the Tape Library
- Operating in Automated Mode
- Powering Off the Tape Library
- Operating In Manual Mode
- 7 Tape Drives in the CTL700 Tape Library
- 8 Configuring the CTL700 Tape Library for the NonStop SSeries Server
- 9 Managing Tape Drives
- A Configuring the CTL700 Tape Library for the NonStop NS-Series Server
- B Configuring the CTL700 Tape Library for the NonStop SSeries Server With the IOAM Enclosure
- C Configuring the CTL700 Tape Library for the NonStop BladeSystem Server
- Safety and Compliance
- Index
Contents
L700 (CTL700) Installation and User’s Guide—527338-008
vi
Table 3-1. Terminate the SCSI BUS 3-12
Table 5-1. Tape Library Configuration Selection 5-3
Table 5-2. Tape Drive Configuration Form 5-4
Table 6-1. Tape Drive Status Messages 6-2
Table 6-2. CAP Status Messages 6-3
Table 6-3. Tape Drive Diagnostic Tests 6-8
Table 9-1. Methods for Controlling Data Compression 9-13
Table A-1. Fibre Channel to SCSI Router LUN Mapping Table A-2