L700 (CTL700) Installation and User's Guide (G06.28+, H06.04+, J06.03+)
Table Of Contents
- Title Page
- Contents
- What's New
- About This Manual
- 1 Overview of the Tape Library
- 2 Unpacking the Tape Library
- 3 Installing the Tape Library
- 4 Controls and Indicators on the CTL700 Tape Library
- 5 Configuring and Testing the Tape Library
- Overview of Configuration
- Tape Library Capacity
- Entering Configuration Data
- Performing the Final Steps
- Initialization Sequence
- Testing the Tape Library
- 6 Operating the Tape Library
- Operating in Automated Mode
- Powering Off the Tape Library
- Operating In Manual Mode
- 7 Tape Drives in the CTL700 Tape Library
- 8 Configuring the CTL700 Tape Library for the NonStop SSeries Server
- 9 Managing Tape Drives
- A Configuring the CTL700 Tape Library for the NonStop NS-Series Server
- B Configuring the CTL700 Tape Library for the NonStop SSeries Server With the IOAM Enclosure
- C Configuring the CTL700 Tape Library for the NonStop BladeSystem Server
- Safety and Compliance
- Index
Operating the Tape Library
L700 (CTL700) Installation and User’s Guide—527338-008
6-7
Reviewing FSC Logs
16. When tape drive cleaning is complete, press the CAP button to open the CAP.
17. Remove the cleaning cartridge, and make a record of how many times it has been
used.
18. Press the CAP button to close the CAP.
Reviewing FSC Logs
A SDE or other Storage Tek representative might ask you to review the tape library’s
Fault Symptom Code (FSC) log so you can better analyze tape library related
problems. The FSC log records significant events, warnings, and errors that the tape
library generates during operation.
To review the FSC log:
1. Press the MENU button until the Main menu appears.
2. If necessary, press the arrow buttons to select FSC LOGS.
3. Press the SELECT button. The panel displays the FSC log screen.
4. Use the arrow buttons to scroll through the log.
This sample entry from the FSC logs screen is followed by an explanation of the entry
elements:
3329 03 NONE
03/01/2002 14:46:14
Note. The Auto Clean feature is automatically enabled if even one cleaning cartridge is loaded
into the reserved cell area and then the tape library is reset.
3229 This 4-character code is the FSC.
03 This value indicates the number of times this FSC has occurred.
NONE This message indicates which, if any, mechanical device was
involved.
03/01/2002 These digits indicate the date the FSC occurred. The fields from
left to right are month, day, and year.
14:46:14 These digits indicate the time the FSC occurred. The fields from
left to right are hour, minutes, and seconds.