ld Manual

ld Diagnostic Messages
ld Manual—529650.001
3-52
Warnings
Recovery. Delete the unsupported attribute in the -set/-change command.
Cause. See message.
Effect. ld continues processing.
Recovery. Call HP. Although a loadfile can have been created, ld should not be
issuing this warning.
Cause. See message.
Effect. ld continues processing.
Recovery. Call HP. Although a loadfile can have been created, ld should not be
issuing this warning.
Cause. User defined a symbol starting with "__TID".
Effect. ld continues processing.
Recovery. Do not define a symbol starting with "__TID". In general, symbols starting
with "__" are reserved for the compiler.
Cause. An unknown relocation section index was encountered in a linkfile.
Effect. ld continues processing.
**** WARNING **** [30006]:
ld was unable to determine the name of the coLD loadsubvolume
SYSTEM.SYS<nn> via the NODE_GETCOLDLOADINFO_system call. ld
is continuing, but ld will not be able to search through the
coLD load subvolume for the standard archives or DLLs.
**** WARNING **** [30007]:
ld was unable to determine its own subvolume through the
PROCESS_GETINFO_ system call. ld is continuing, but ld will
not be able to search through its own subvolume for archives
or DLLs.
**** WARNING **** [30009]:
The load file produced by this ld run will probably not work.
An error was detectd that indicated the likely use of a
symbol prefixed with'__TID_'. This prefix is normally used by
the compiler to generate special symbols which ld then uses.
**** WARNING **** [30010]:
'add_relscn' problem. 'pmext' is NULL.