Native Inspect Manual (H06.03+)

Introducing Native Inspect
Native Inspect Manual—528122-003
1-6
Process Debugging With Native Inspect
•
For a comparison of Inspect and Native Inspect commands, see:
°
Table A-2 on page A-2 for a list of Inspect commands and equivalent Native
Inspect commands.
°
Table 2-1 on page 2-1 for a list of the most commonly used Native Inspect
commands with their Inspect equivalents.
Process Debugging With Native Inspect
Use Native Inspect to debug TNS/E native processes (and snapshots) in either the
Guardian or HP NonStop Open System Services (OSS) environment.
The Native Inspect licensed object file is $SYSTEM.SYSnn.EINSPECT. Native Inspect
runs as a native, non-priv, high-pin process, separate from the process being
debugged (see Comparing Native Inspect to Debug on page 1-4).
Native Inspect must always be running in the same CPU as the process you want to
debug, as shown in Figure 1-1 on page 1-7.
Languages Supported by Native Inspect
•
TNS/E native C/C++
•
pTAL
To debug code written in any other language (such as COBOL) for TNS/E systems, or
snapshots created on a TNS/R system, you must use Visual Inspect.