Native Inspect Manual (H06.04+)

Syntax of Native Inspect Commands
Native Inspect Manual—528122-005
4-54
next command, nexti command
value
is the value you want to assign to native-address. The options 8, 16, 32, and
64 specify the bit size of value.
After completion of the command, Native Inspect prints out the address that was
modified, the number of bytes that were modified, and the old and the new values. If
the specified value does not fit in the size specified, an error is returned.
Example
The command:
returns an error because the value 0xFFFF is larger than the specified size of 8 bits.
next command, nexti command
Advances program execution to the next statement or instruction, respectively. For
COBOL programs, advances execution to the next verb. Execution steps over any
function calls or PERFORM statements executed within the step range.
Next and nexti are similar to the step command, stepi command.
Aliases: n, ni
count
is a positive integer specifying the number of statements (next command) or
instructions (nexti command) to advance.
Example
To step execution using the next, step, and finish commands:
(eInspect 4,28): m 0x4FFFFE00 0xFFFF 8
{ next | nexti } [ count ]
(eInspect 1,329):next
351 pcb = PCB_create();
(eInspect 1,329):step
PCB_create () at \SIERRA.$YOSE1.SYMBAT1.SCXXTST:226
226 {
(eInspect 1,329):next
227 PCB_t *pcb = (PCB_t *) malloc( sizeof( PCB_t ) );
(eInspect 1,329):next
228 memset( pcb, 0, sizeof( PCB_t ) );
(eInspect 1,329):finish
Run till exit from #0 PCB_create () at \SIERRA.$YOSE1.SYMBAT1.SCXXTST:228
0x70002520:0 in pcbDataStructs_initialize ()
at \SIERRA.$YOSE1.SYMBAT1.SCXXTST:351
351 pcb = PCB_create();
Value returned is $2 = (PCB_t *) 0x0