Native Inspect Manual (H06.07+)

Introducing Native Inspect
Native Inspect Manual—528122-006
1-7
Starting Native Inspect
Starting Native Inspect
You can start or enter Native Inspect in several ways:
•
You can start a process under the control of the debugger, subject to the Debugger
Selection Criteria (using the TACL RUND command or the run -debug command
in OSS).
•
You can debug a running process (using the TACL DEBUG command).
•
A running process can invoke the debugger (calling the PROCESS_DEBUG_ or
DEBUG procedure, by encountering a breakpoint, or as a result of an unhandled
signal).
•
You can explicitly start Native Inspect from a TACL prompt or from OSS.
These methods are described next.
Figure 1-1. Native Inspect Runs in Same CPU as Current Process
User Terminal
NonStop TNS/E Host
CPU 1 CPU 2
Native
Inspect
Current
Process
VST0101.vsd