Native Inspect Manual (H06.13+, J06.03+)

Related Commands: Detach is the complement of the attach command. (See attach Command

(page 66).)

detach [pin] | [$process-name]

Where:

The process number of a process under the control of Native Inspect from which you want to

detach.

$process-name

The name of the process or process-pair under the control of Native Inspect from which you

want to detach.

Considerations

• Before entering the detach command, you should typically clear all breakpoints in the process

and continue process execution. If breakpoints are set in the process, Native Inspect displays

a confirmation prompt.

• If the process you name in a detach command is suspended, it will automatically be resumed.

• If you enter the detach command when breakpoints are set in the process, Native Inspect

issues a warning describing the situation and gives you the option of continuing or aborting

the operation.

Example

See the section titled: Example of Using Multiple Instances of Native Inspect (page 26)

dir Command

Appends a specified directory to the search path that Native Inspect uses to locate source files.

The directory search path is shared by all programs that are currently being debugged by Native

Inspect.

You typically use the dir command to help Native Inspect find source files when their current

location differs from the location at which they were compiled, but their base file name remains

the same. You use the related map command (see map-source-name (map) Command (page 99))

to specify base file name changes between compilation and debugging.

If you do not specify a directory, the search path is reset to empty (that is, Native Inspect searches

for source files only in the directory from which the source file was compiled).

dir [directory]

Where: