NonStop NS-Series Planning Guide (H06.03+)

Specifications
HP Integrity NonStop NS-Series Planning Guide—529567-004
A-3
Enclosure Power Loads
Enclosure Power Loads
Power and current specifications for each type of enclosure are:
Model R5500 XR Integrated UPS
For complete information and specifications, refer to the HP UPS R5500 XR Models
User Guide (HP part number 351642).
Enclosure Type
AC Power
Lines per
Enclosure
1
Apparent Power
(volt-amps
measured on
single AC line
with one line
powered)
Apparent Power
(volt-amps
measured on
single AC line
with both lines
powered)
6
Peak
Inrush
Current
(amps)
Four-processor slice:
16 GB memory boards
32 GB memory boards
2
2
680
710
Per line:
380
390
Total:
760
780
17
17
LSU (with four LSUs) 2 150 110 220 67
Processor switch
2
2 160 100 200 5
IOAM
3
4 420 250 500 68
Disk drive
4
2 220 140 280 14
Maintenance switch
(Ethernet)
5
150 --4
1
Half of the plugs for an enclosure must be connected to the right-side PDU and the other half connected to the
left-side PDU. PDUs must be supplied from separate branch circuits.
2
Measured with three PICs installed and active,
3
Measured with 10 Fibre Channel ServerNet adapters installed and active.
4
Measured with 14 disk drives installed and active.
5
Maintenance switch has only one plug. This plug must be connected to the right-side PDU (the PDU that is
supplied by a UPS, if installed).
6
. Total apparent power is the sum of the two AC power lines feeding the enclosure. Electrical load is shared
equally between the two lines.
Version
Operating
Voltage Settings
Power Out
(VA/Watts) Input Plug Branch Circuit
North America
and Japan
200/208*, 220,
230, 240
5000/4500 L6-30P Dedicated 30 Amp
Other
International
200, 230*, 240 6000/5400 IEC-309 32
Amp
Dedicated 30 Amp
If 200/208 Then 5000/4500
* factory-default setting