NonStop NS-Series Planning Guide (H06.03+)

Example Modular Configurations
HP Integrity NonStop NS-Series Planning Guide—529567-004
B-27
Example 16-Processor Triplex System Cabling
Components of the cable management system that are part of each modular enclosure
as well as the rack are not shown, so actual cable routing using is slightly different form
that shown. For detailed information on cable routing and connection as part of the
system installation, refer to the Integrity NonStop NS-Series Hardware Installation
Manual.
The next illustration shows the cabinets that house the modular I/O hardware and that
connect to the processor cabinets in the preceding illustration.
This drawing shows simplified representation of the X and Y ServerNet cabling
between the IOAM enclosures and the p-switches and the Fibre Channel cabling
between the FCSAs and disk drive enclosures. The example disk drive enclosure
configuration for the group 110 IOAM is the four-FCSA, four-disk drive enclosure
configuration shown in detail in Four FCSAs, Four DDEs, One IOAM Enclosure on
page 4-25. The disk drive enclosures for the group 111 IOAMs is a daisy-chain
configuration shown in detail in Daisy-Chain Configurations on page 4-28.
From X P-Switch
Slot 4
VST702.vsd
From Y P-Switch
Slot 4
From Y P-Switch
Slot 5
From X P-Switch
Slot 5
IOAM
111.3
IOAM
111.2
DDE 4
DDE 3
DDE 2
DDE 2
IOAM
110.3
IOAM
110.2
DDE M2
DDE P2
DDE M1
DDE P1
DDE M2
DDE P2
DDE M1
DDE P1
Cable Handler