NonStop NS-Series Planning Guide (H06.05+)

System Configuration Guidelines
HP Integrity NonStop NS-Series Planning Guide—529567-008
6-2
Enclosure Locations in Cabinets
This example shows one possible system configuration using a duplex processor, or
two NonStop Blade Elements:
For other example configurations, see Section 7, Example Configurations.
Enclosure Locations in Cabinets
In this table, the enclosure location refers to the U in the cabinet where the lower edge
of the enclosure resides, such as the bottom of a NonStop Blade Element enclosure at
28U.
Enclosure or
Component
Height
(U)
Required Cabinet
Location Notes (page 1 of 2)
PDUs N/A AC power cord for the
PDU exiting out the top
rear corner
AC power cord for the
PDU exiting out the bottom
rear corner
For top feed AC (with and
without the optional UPS).
For bottom feed AC (with and
without the optional UPS).
HP R5500 XR UPS 3U Bottom U of modular
cabinet
If the maintenance switch is
installed in U1, install the UPS
in U2.
VST423.vsd
IOAM
Enclosure
PDU
Maintenance
Switch
P-Switch
Y Fabric
P-Switch
X Fabric
LSU
Enclosure
NSBE B
NSBE A
To AC Power Source or Site UPS
Fibre Channel
Disk Modules