NonStop NS-Series Planning Guide (H06.05+)

Example Configurations
HP Integrity NonStop NS-Series Planning Guide—529567-008
7-2
Typical Configurations
Typical Configurations
This subsection shows the U locations of the modular hardware installed in typical
configurations. These options can be installed in locations marked Available Space in
the configuration drawings:
•
Maintenance switch: 1U required
•
Tape converter (NonStop S-series connect: 1U required)
•
Fibre connect tape with ACL: 5U required
•
Console: 2U required with recommended installation at cabinet offset 20U
•
Fibre Channel Disk Module: 3U required
Topics covered are:
IOAM
enclosure
126 12 6
FCSA 2 Up to 20
in mixture
set by
disks and
I/O
Up to 60
in mixture
set by
disks and
I/O
2 Up to 20
in mixture
set by
disks and
I/O
Up to 60
in mixture
set by
disks and
I/O
G4SA 2 2
Fibre Channel
disk module
248 24 8
Fibre Channel
disk drives
14 56 112 14 56 112
Topic Page
Duplex 8-Processor System, Two Cabinets
7-3
Duplex 16-Processor System, Three Cabinets 7-4
Duplex 16-Processor System, Two Cabinets 7-5
Triplex 8-Processor System, Two Cabinets 7-6
Triplex 16-Processor System, Three Cabinets 7-7
Example System With UPS and ERM 7-8
Example System With One NonStop S-Series I/O Enclosure 7-9
Enclosure or
Component
(page 2 of 2)
Duplex Processor Triplex Processor
Minimum Typical Maximum Minimum Typical Maximum