NonStop NS1000 Planning Guide (H06.05+)

Modular System Hardware
HP Integrity NonStop NS1000 Planning Guide—542527-004
5-9
Fibre Channel Disk Module
•
The maintenance entity on the ServerNet switch board supports direct connections
to blade elements and ServerNet I/O adapters.
•
Up to four 4PSEs provide ServerNet connectivity to the blade elements.
•
Only 4PSEs are supported for installation in slots 2.1, 2.2, 3.1, and 3.2 of the IOAM
enclosure for an Integrity NonStop NS1000 server.
•
Up to six ServerNet I/O adapters are supported, and a minimum of two FCSAs and
two G4SAs must be installed. Fibre Channel ServerNet adapters (FCSAs) are
used for communicating with storage devices such as a Fibre Channel Disk
Module, tape devices, or an Enterprise Storage System (ESS) disk. Gigabit
Ethernet 4-port ServerNet adapters (G4SAs) are used for Ethernet connectivity.
•
FCSAs and G4SAs are supported for installation in slots 2.3, 2.4, 2.5, 3.3, 3.4, and
3.5 of the IOAM enclosure for an Integrity NonStop NS1000 server.
•
In OSM, IOAM power supplies have actions to configure the power source as AC
in case of power failure.
Fibre Channel Disk Module
The Fibre Channel disk module (FCDM) is a storage device containing disk drives that
connect to an FCSA in an IOAM enclosure in an Integrity NonStop NS1000 server. For
a general description of the Fibre Channel disk module, refer to the NonStop NS-
Series Planning Guide. Details about the use or implementation of the Fibre Channel
disk module that are specific to an Integrity NonStop NS1000 server are presented
here.
•
Only configurations with one IOAM enclosure containing a maximum of 4 FCSAs
are supported. The IOAM enclosure group number is 100.
•
FCSAs are supported for installation in slots 2.3, 2.4, 2.5, 3.3, 3.4, and 3.5 of the
IOAM enclosure for an Integrity NonStop NS1000 server. However, a minimum of
two FCSAs and two G4SAs must be installed.
•
Up to four FCDMs with 14 disk drives in each FCDM can be daisy-chained
together for a maximum of 16 FCDMs in the Integrity NonStop NS1000 server.
Tape Drive and Interface Hardware
For an overview of tape drives and the interface hardware, see FCSA to Tape Devices
on page 6-9.
Maintenance Switch (Ethernet)
The HP ProCurve 2524 maintenance switch provides the communication between the
Integrity NonStop NS1000 system at the switch boards in the IOAM enclosure and the
system console running HP NonStop Open System Management (OSM). For a general
description of the maintenance switch, refer to the NonStop NS-Series Planning Guide.