NonStop NS1000 Planning Guide (H06.05+)

Modular System Hardware
HP Integrity NonStop NS1000 Planning Guide—542527-004
5-13
Blade Element Group-Module-Slot Numbering
Example: module 1 = any blade element
°
100-107 relates to processors 0-7
Example: module 102 = processor 2
°
In the OSM Low-Level Link, 100 through 107 relates to processors 0 through 7
Example: module 103 = processor 3
•
Slot:
°
In OSM Service Connection displays:
°
2 relates to the location of the ServerNet PCI adapter card in the PCI slots.
Only slot 2 is used.
°
3 through 4 relates to the location of the power supplies on the blade
element.
Example: slot 3 = the power supply in slot 3
°
17 through 19 relates to the location of the fan assemblies on the blade
element.
Example: slot 18 = the fan assembly in slot 18
°
In the OSM Low-Level Link, 1 relates to the location of the processor. Because
each blade element contains only one processor, it is always located in slot 1.
Example: slot 1 = any processor in any blade element.
•
Port: X and Y relate to the two ServerNet fabric ports in slot 2.
Example: Port X = Right port connecting to the ServerNet X fabric when facing the
blade element from the rear.
This table shows the default numbering for the blade elements of an Integrity NonStop
NS1000 system when blade elements are powered on and functioning:
Note. In OSM, if a blade element is not present or is powered off, processors might be
renumbered. For example, if processor 3 has been removed, processor 4 becomes processor
3 in OSM displays.