NonStop NS1000 Planning Guide (H06.05+)
System Configuration Guidelines
HP Integrity NonStop NS1000 Planning Guide—542527-004
6-22
Default Naming Conventions
Default Naming Conventions
The Integrity NonStop NS1000 system implements default naming conventions in the
same manner as other Integrity NonStop NS-series systems.
With a few exceptions, default naming conventions are not necessary for the modular
resources that make up an Integrity NonStop NS1000 system. In most cases, users
can name their resources at will and use the appropriate management applications and
tools to find the location of the resource.
However, default naming conventions for certain resources simplify creation of the
initial configuration files and automatic generation of the names of the modular
resources. When autoconfigure mode is set to ON for storage devices, the
preconfigured default naming convention is used to generate the names of the Fibre
Channel disk drives. Preconfigured default resource names are:
On new NonStop systems, only one of each of these processes and names is
configured:
•
TCP6SAM - $ZTC0
•
Telserv - $ZTCN0
•
Listener - $LSN0
Type of Object Naming Convention Example Description
Fiber Channel
disk drive
$FC number $FC10 Tenth Fibre Channel disk
drive in the system
ESS disk drive $ESS number $ESS20 Twentieth ESS disk drive
in the system
Modular tape
drive
$TAPE number $TAPE01 First modular tape drive in
the system
G4SA G group module slot G10023 G4SA in location 100.2.3
G4SA LIF L group module slot port L10023B LIF for PIF at location
100.2.3.0.B
TCP/IP process $ZTC number $ZTC0 First TCP6SAM or TCP/IP
process for the system
Telserv process $ZTN number $ZTN0 First Telserv process for
the system
Listener
process
$LSN number LSN0 First Listener process for
the system
TFTP process Automatically created by
WANMGR
None None
WANBOOT
process
Automatically created by
WANMGR
None None