NonStop NS1000 Planning Guide (H06.06+)

Control, Configuration, and Maintenance Tools
HP Integrity NonStop NS1000 Planning Guide—542527-002
B-3
System Console Configurations
One System Console Managing One System (Setup
Configuration)
The one system console on the LAN must be configured as the primary system
console. This configuration can be called the setup configuration and is used during
initial setup and installation of the system console and the server. When you use this
configuration, you do not need to change the preconfigured IP addresses.
The setup configuration is an example of a secure, stand-alone network. A LAN cable
connects the primary system console to the maintenance switch, and additional LAN
cables connect the ServerNet switch boards in the IOAM enclosures and G4SA ports.
The maintenance switch or an optional second maintenance switch allows you to later
add a backup system console and additional system consoles.
Note. Because the system console and maintenance switch are single points of failure that
could disrupt access to OSM, this configuration is not recommended for operations that require
high availability or fault tolerance.
Maintenance
Switch 1
Secure
Operations LAN
IOAM Enclosure
10/100 ENET
Port, ServerNet
Switch Boards
Remote
Service
Provider
DHCP
DNS
server
(optional)
G4SA FCSA G4SA FCSA
4PSE
FCSA FCSA
Optional
Connection to
a Secure
Operations
LAN
(One or Two
Connections)
Modem
Primary System Console
4PSE 4PSE 4PSE
VST073.vsd