NonStop NS1000 Planning Guide (H06.06+)

HP Integrity NonStop NS1000 Planning Guide—542527-002
2-1
2 Installation Facility Guidelines
This section provides guidelines for preparing the installation site for Integrity NonStop
NS1000 systems:
Modular Cabinet Power and I/O Cable Entry
Power and I/O cables can enter the Integrity NonStop NS1000 server from either the
top or the bottom rear of the modular cabinets, depending on how the cabinets are
ordered from HP and the routing of the AC power feeds at the site. Integrity NonStop
NS1000 server cabinets can be ordered with the AC power cords for the PDUs exiting
either:
•
Top: Power and I/O cables are routed from above the modular cabinet.
•
Bottom: Power and I/O cables are routed from below the modular cabinet
For information about modular cabinet power and cable options, refer to Modular
Cabinets on page 5-3.
Topic Page
Modular Cabinet Power and I/O Cable Entry
2-1
Emergency Power-Off Switches 2-2
Electrical Power and Grounding Quality 2-2
Uninterruptible Power Supply (UPS) 2-3
Cooling and Humidity Control 2-4
Weight 2-5
Flooring 2-5
Dust and Pollution Control 2-5
Zinc Particulates 2-6
Space for Receiving and Unpacking the System 2-6
Operational Space 2-6
Note. If your system includes the optional rackmounted HP R5500 XR UPS, the modular
cabinet will have one PDU located on the rear left side and four extension bars on the rear right
side. The R5500 XR UPS AC input power cord is routed as described above, and the large
output receptacle is unused.