NonStop NS1000 Planning Guide (H06.07+)

System Installation Specifications

HP Integrity NonStop NS1000 Planning Guide—542527-003

3-2

Verify the Processor Type

The SYSTEM_PROCESSOR_TYPE for and Integrity NonStop NS1000 system should

be specified as NSE-P in the CONFTEXT configuration file:

Changing the CONFTEXT File

You can modify the CONFTEXT file using DSM/SCM. Any changes to the CONFTEXT

file take effect after the next system load. Refer to the DSM/SCM User’s Guide.

Modular Cabinet AC Input Power

Power can enter the Integrity NonStop NS1000 server from either the top or the bottom

rear of the modular cabinets, depending on how the cabinets are ordered from HP and

the routing of the AC power feeds at the site. Integrity NonStop NS1000 server

cabinets can be ordered with the AC power cords for the PDU installed either:

•

Top: Power and I/O cables are routed from above the modular cabinet.

•

Bottom: Power and I/O cables are routed from below the modular cabinet

For information on the modular cabinets, refer to Modular Cabinets on page 5-3. For

information on the PDUs, refer to Power Distribution Units (PDUs) on page 5-5.

ALLPROCESSORS:

SYSTEM_PROCESSOR_TYPE NSE-P

Note. The OSM Service Connection will display the processor type as NSE-B.

Topic Page

North America and Japan: 208 V AC PDU Power

3-3

North America and Japan: 200 to 240 V AC PDU Power 3-3

International: 380 to 415 V AC PDU Power 3-4

International: 200 to 240 V AC PDU Power 3-4

Grounding 3-4

Branch Circuits and Circuit Breakers 3-5

Enclosure AC Input 3-5

Enclosure Power Loads 3-6

Model R5500 XR Integrated UPS 3-7

Note. If your system includes the optional rackmounted HP R5500 XR UPS, the modular

cabinet will have one PDU located on the rear left side and four extension bars on the rear right

side. To provide redundancy, components are plugged into the left-side PDU and the extension

bars. Each extension bar is plugged into the UPS. The R5500 XR UPS AC input power cord is

routed as described above, and the large output receptacle is unused.