NonStop NS1000 Planning Guide (H06.08+)

About This Document
This guide describes the HP Integrity NonStop™ NS1000 system and provides examples of
system configurations to assist you in planning for installation of a new system.
Supported Release Version Updates (RVUs)
This publication supports H06.08 and all subsequent H-series RVUs until otherwise indicated
by its replacement publication.
NOTE: For NonStop NS1000 servers that contain I/O Adapter Module (IOAM) enclosures,
refer to the H06.07 (or earlier) version of this manual for planning, configuration, and maintenance
information of the IOAM enclosure.
Intended Audience
This guide is written for those responsible for planning the installation, configuration, and
maintenance of the server and the software environment at a particular site. Appropriate personnel
must have completed HP training courses on system support for Integrity NonStop NS1000
servers.
NOTE: Integrity NonStop NS1000 refers to hardware systems. H-series refers to release version
updates (RVUs). H-series RVUs run on Integrity NonStop NS1000 servers and other Integrity
NonStop servers.
New and Changed Information
These chapters and appendices have been changed for the editions, as indicated. All changes are
marked with change bars.
New and Changed Information for 542527–010
• Under “Default Startup Characteristics” (page 44), added a note stating that the
configurations documented here are typical for most sites. Your system load paths might
be different, depending upon how your system is configured. To determine the configuration
of your system, refer to the system attributes in the OSM Service Connection. You can select
this from within the System Load dialog box in the OSM Low-Level Link.
• Made additions and changes to the “Internal Cables” (page 107) table.
• Made changes to the “Enclosure Dimensions” (page 32) table.
• Made changes to the “Modular Cabinet and Enclosure Weights With Worksheet” (page 32)
table.
• Changed figures to show appropriate system console icon.
• Changed the C13 receptacle type from 10A to 12A in these sections:
— “North America and Japan: 208 V AC PDU Power” (page 26)
— “North America and Japan: 200 to 240 V AC PDU Power” (page 26)
— “International: 380 to 415 V AC PDU Power” (page 27)
— “International: 200 to 240 V AC PDU Power” (page 27)
— “North America and Japan 208 V AC input, 3-phase delta, 24A RMS Power” (page 51)
— “North America and Japan 200 to 240 V AC input, Single phase, 40A RMS Power”
(page 51)
— “International 380 to 415 V AC input, 3-phase Wye, 16A RMS Power” (page 51)
Supported Release Version Updates (RVUs) 9