NonStop NS1200 Planning Guide

New and Changed Information for 544844–005
• Made additions and changes to the “Internal Cables” (page 77) table.
• Under Appendix C: Default Startup Characteristics (page 83), added a note stating that the
configurations documented here are typical for most sites. Your system load paths might
be different, depending upon how your system is configured. To determine the configuration
of your system, refer to the system attributes in the OSM Service Connection. You can select
this from within the System Load dialog box in the OSM Low-Level Link.
New and Changed Information for 544844–004
• Changed figures to show appropriate system console icon.
• Under “Modular Cabinets” (page 37), added note: For instructions on grounding the modular
cabinet's G2 rack using the HP Rack Grounding Kit (AF074A), ask your service provider to
refer to the instructions in the HP 10000 G2 Series Rack Options Installation Guide. This
manual is available at: http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/
c01493702/c01493702.pdf.
• Under Chapter 6: Maintenance and Support Connectivity (page 67), indicated that the HP
ISEE call-out and call-in access is determined by what access method (for example, direct
connect or VPN router) you have ordered.
• Added new procedures to “AC Power Monitoring” (page 80), including the new subsections,
“How OSM Power Failure Support Works” (page 81), “Considerations for Ride-Through
Time Configuration” (page 81), and “Considerations for Site UPS Configurations” (page 82).
New and Changed Information for 544844–003
• Corrected the operating temperatures under “Operating Temperature, Humidity, and
Altitude” (page 48) and “Nonoperating Temperature, Humidity, and Altitude” (page 49).
• Indicated under “Default Naming Conventions” (page 60) that changing the process names
for $ZTCP0 and $ZTCP1 will make some components inaccessible.
• Changed the weight of the PDU monitored configuration from 303 lbs. to 328 lbs. due to the
additional weight of the rack extension. See Table 3-1: Example of Cabinet Load Calculations
(page 50) and “Modular Cabinet and Enclosure Weights With Worksheet ” (page 47).
• Changed VIO “IP Addresses” (page 69) from 192.231.36.222 to 192.231.36.202 and
192.231.36.223 to 192.231.36.203.
New and Changed Information for 544844–002
The following topics have been updated:
• “IP Addresses” (page 69)
• “One System Console Managing One System (Setup Configuration)” (page 74)
• “Primary and Backup System Consoles Managing One System” (page 75)
Document Organization
ContentsSection
This chapter provides an overview of the modular
Integrity NonStop NS1200 system.
Chapter 1 (page 15)
This chapter outlines topics to consider when planning
or upgrading the installation site.
Chapter 2 (page 31)
This chapter provides the installation specifications for a
fully populated Integrity NonStop NS1200 enclosure.
Chapter 3 (page 37)
10